Wall Panel 37F Grey Oak: 4cm slats and a 5cm repeat

The Wall Panel 37F in grey oak publishes the two figures that decide how a slat wall looks: a 4cm slat with a 1cm space beside it. It is also a deeper panel than the 1.7cm ones in the 36 group, at 2.2cm, and both of those numbers have practical consequences.

4cm slats read as lines, not texture

Narrow slats close together blur into a texture a few steps back. A 4cm slat holds its own line at any distance, so the wall stays graphic rather than soft. That suits a long wall, a stairwell or a double-height space, where fine slats can look busy. It is less forgiving in a small room, where strong vertical lines on a short wall draw attention to how short it is. The same finish with the finer rhythm is Wall Panel 36F, at 2.5cm slats and 1cm gaps, if that is the way your room points.

A 5cm repeat divides a 60cm panel exactly

4cm of slat plus a 1cm gap repeats every 5cm, and 60 divides by 5 twelve times without a remainder. That is genuinely useful. The repeat ends where the panel ends, so the join between two panels can be kept to the same visual beat as the slats themselves, and a cut lands on a predictable line. It also makes a feature width easy to plan in your head: 50cm of wall is ten repeats, 1m is twenty. The listing does not say how the edge slat at each side of the panel is finished, so look at the photographs before assuming the join will vanish completely.

2.2cm of depth, and the three places it shows

At 2.2cm this is deeper than the 1.7cm panels in the 36 group, which gives a longer shadow in each gap and a heavier reveal at the edges. It also takes more off the room:

• Sockets and switches finish 2.2cm behind the new face and need extension boxes or a surface pattress.
• Skirting, architrave and window boards all have to be dealt with, by removing and refitting them over the panel or by stopping the panel short and trimming the gap.
• Radiator valves, door swings and a wardrobe pushed against the wall all lose that 2.2cm, which is worth a tape measure in a narrow room.

Quantities, and the last panel

Wall width divided by 60 gives the panels, and a quarter of that, rounded up, gives the packs. Where the width is not a multiple of 60, split the difference: taking a little off the first and last panel rather than leaving one narrow strip at one end looks better and costs nothing but a second cut.

What the listing does not quantify

The sound wording is construction, not measurement: HDF slats on a felt backing described as absorbing sound and reducing noise, with no coefficient and no test standard. Grey oak is named but not described, so the tone is a question for the shop if it has to sit beside an existing floor. And the number of slats on a panel is nowhere on the listing, which is why the figure above comes from dividing 60 by 5 rather than from the specification.

Corner and edge strips are in panel trims and fittings, where each trim is listed against the panel numbers it suits, so check which one fits this panel. The wall panel adhesive is sold by the box. The same wide slat comes in walnut as 37WT, and the full set of profiles is in slat and acoustic panels. When the wall is measured and the depth accounted for, order the Wall Panel 37F grey oak acoustic panel in a single order so the batch matches. Delivery is free within 50 miles of the Glasgow store and £50 beyond.